libmbim 1.0.0 released!
Just tagged a 1.0.0 release for libmbim, a library which helps you talk to MBIM-capable modems. You can read more about the MBIM protocol in the libmbim introduction blogpost I wrote some months ago. The 1.0.0 tarball is ready for download from freedesktop.org:
If you want to easily talk to a MBIM device from a GLib-based application, you may want to check the libmbim API documentation.
libmbim is currently used by ModemManager (git master), but you can also now use it in standalone mode with either mbimcli (the command line utility) or mbim-network (a helper script to launch a connection):
# echo "APN=Internet" > /etc/mbim-network.conf
# mbim-network /dev/cdc-wdm0 start
Starting network with 'mbimcli -d /dev/cdc-wdm0 --connect=Internet --no-close'...
Network started successfully
# mbim-network /dev/cdc-wdm0 status
Getting status with 'mbimcli -d /dev/cdc-wdm0 --query-connection-state --no-close'...
# mbim-network /dev/cdc-wdm0 stop
Stopping network with 'mbimcli -d /dev/cdc-wdm0 --disconnect'...
Network stopped successfully
As with libqmi’s qmi-network script, you’ll still need to run a DHCP client on the wwan interface after getting connected through MBIM. Note that your modem may not support DHCP… if that’s your case then patches are welcome to update the script to dump the IP configuration 🙂 Or just use ModemManager, which works nicely with the static IP setup.